Hello,
I am new to TypeDrawers. I have just had a group project at school where we had to make a magazine. We chose to make one on green technology, and I offered to make our wordmark because I hope to do type design and lettering. I have been inspired by Museo Slab and Didot. I have used Adobe Illustrator and Glyphs. I was wondering if anyone would give constructive criticism. I am self-taught on what I know about type design and lettering because it is not something that is popular in Denmark. Thank you!
—Mads
Comments
Welcome! Here my two cents, hope it helps.
/R stands out, looks heavy and possibly wide... you might want to compensate the stem on the left as well as top bowl to make these a touch lighter. In other words, I'd try to insert more white inside the letter. Also, not sure if the type of curve you drew match the concept. Perhaps something more mechanical would fit better.
/T looks a bit weak, you could try to make top serifs longer.
Bear in mind that the you can compensate the length of the serifs here and there, they don't need to be always the same. Look at the white gap on the top of /V. It looks successful to me. Try to replicate that for /R and /X so that they look the same, optically.
I checked to see the width of Didot’s <R>, and it had the same measurements on its vertical stem, its bowl and its tail. I thought you had to use the same measurements?
I am not used to using serifs; I thought if they were of different lengths, they would be unbearably inconsistent.
Thanks again! Now I am going back to Glyphs!
Thank you. I have reduced the weight on the right side after studying Birra from Darden Studio. I have to think about what I will do with the <T>.